Plate assembly can take junction technology is used to connect the use of bolts fastening installation is made, the tank and tank top materials are used in line with national standards (Q235-B) steel plate, steel machinery in the factory will be processed after the vertical, horizontal take the knot, take the junction with professional polysulfide polymer rubber sealing material sealing assembly to its portfolio. The company's assembly tank corrosion using advanced surface treatment technology, "cathodic electrophoretic process" technology, technology of production than the enamel difficulty is low, compared with conventional anti-corrosion treatment technology with anti-corrosion effect, and high temperature resistance, abrasion resistance, impact resistance , during transport can reduce or avoid the collision damage, and to overcome the enamel tank assembly during transportation and installation of the collision caused a large area out of porcelain and ceramic explosion phenomenon. 
 The product can be a complex installation process of welding and the concrete pouring process to produce factory, process simplification, so that lower input costs, and do not put a lot of manpower and resources, all processing of all the factory completed. Construction of sewage, gas processing cost of the project investment is a very important factor, the standard of advanced water treatment technology should be suitable for China's national conditions, high efficiency, low consumption, low-cost wastewater treatment technology. At present, China's sewage treatment works in the common pool of reinforced concrete and steel tanks do not have that. Complex process of steel-concrete pool construction, long life cycle, structural design cumbersome, high cost, not applicable to small and medium sized sewage treatment works; and welded steel tanks on-site welding, is difficult to guarantee the quality of construction, and corrosion resistance is poor, life is short, pool capacity is small; above two reactors have certain limitations. Treatment for a certain degree of standardization is to reduce the design and equipment costs, improve efficiency and effective means of 
 The world, Germany, France, the Czech Republic and other advanced countries began in the seventies urban sewage and industrial wastewater treatment project has been the introduction of new equipment, new materials, new techniques to design and construction. Can assembly technology is one of them. By special construction techniques and equipment will be assembled into a volume of steel 50-10000m3 reactor. Verified by decades of engineering, the technology has a short construction period, low cost, corrosion resistance, and can be any expansion and mobile, etc., so that the wastewater treatment plant to a small investment, fast production, can be relocation target.